The start-up of the new battery includes adding electrolyte, charging and device, which is usually completed by the service personnel of the lithium battery shop authorized to repair electric motorcycles. The user can first check the appearance of the battery, such as whether the shell has scars and cracks, and the terminal should be free of inclination and deformation. Be careful not to bend, block or press the vent pipe of the flat battery during operation.
Application and protection of lithium ion battery for motorcycle
Press the button every time you start, and the time for the lithium battery manufacturer of the electric motorcycle shall not exceed 5 seconds. If it cannot be started for several consecutive times, check the lithium battery manufacturer of the electric motorcycle to see the oil supply system, starting and incineration system.
The following conditions will lead to over discharge or lack of charge of the battery and shorten the service life of the battery:. Frequent start and short travel interval. Travel at low speed for a long time. Hold the brake handle tightly or step on the rear brake pedal to keep the brake light on. Device rated electrical accessories or replace with high-power bulbs.
When it is difficult to start, the lights are dim and the horn is not loud, the power shall be supplemented immediately.
Check the liquid level every 1-3 months. If the liquid level is lower than the minimum liquid level line, add distilled water to the high liquid level line. After adding water, it is best to supplement electricity. The unprotected battery is outside.
When the motorcycle is not used for a long time, please recharge it before stopping use, remove it for storage and replenish it once a month.
Safety precautions of lithium ion battery for motorcycle
Explosive gas will occur when the battery is used and charged. It is forbidden to approach open fire or high temperature. It shall also prevent positive and negative short circuits and loosening of positive and negative terminals.
Electrolyte contains strong acid to prevent splashing on skin, eyes and clothes. Once touched, clean immediately with plenty of water. If you take it by mistake, you should drink a lot of water or milk immediately and send it to the hospital for treatment.
Adding rated power accessories such as anti-theft device will have a certain impact on the battery.
Method for safe use of lithium ion battery for motorcycle
1. Use protective articles when adding electrolyte to prevent electrolyte from overflowing or splashing on the skin.
2. The remaining electrolyte shall be properly kept in the container and neutralized with quicklime when scrapped.
3. Open the filling plug before charging, because a large amount of gas will be released from the battery during charging. In addition, pay attention to good ventilation in the charging room and strictly prohibit smoking.
4. The waste battery shall be treated in time to prevent electrolyte from flowing out and damaging the surrounding articles, and children shall not play with it.
5. When the electrolyte touches the skin, wash it with clean water immediately; In case of splashing people’s eyes, wash them with clean water immediately for 15min.
6. Eat the electrolyte into the body by mistake, drink several mouthfuls of clear water immediately, and then mix the egg white and emulsion of the egg; You can also drink plenty of water and rest.
7. When electrolyte is splashed on clothes, wash them with water immediately, and then neutralize them in weak alkali solution.